Kohler K-8040-2A-CP Installation Guide download pdf (Page 11)

9. Install the Drain and Supplies

IMPORTANT! The drain steps apply to the K-8040 and K-8046

models only.

Install the drain according to the drain manufacturer’s

instructions.

If necessary, connect the lift rod assembly.

Cut the supply tubes, making sure there is enough length for the

required penetration of the tubes into the supply-stops.

Debur all tubing cuts.

Slip the coupling nuts onto the supply tubes.

Carefully position the round end of the supply tube (either ﬂared

end or ferrule) squarely into the valve body inlet.

Hand tighten the coupling nuts.

Carefully bend the supply tubes to align with the supply stops.

Slide a coupling nut, then a ferrule, onto each supply tube.

Insert the supply tubes into supply stop outlets, positioning the

round ends of the ferrule squarely into the outlets.

Tighten all coupling nuts.

Trip

Lever

Push

Rod

Lift

Rod

Cotter

Valve

Yoke

Supply Tube

Coupling Nut

Ferrule

Supply Stop

Kohler Co. 11 111290-2-BC

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

Kohler K-8040-2A-CP Installation Guide Page 11