Kohler K-1913-LW-47 Installation Guide download pdf (Page 22)

12. Install the Receptor Tray, and Connect the Drains

All Installations

Install the drain to the receptor tray following the drain manufacturer’s instructions.

When Reassembling the Receptor:

NOTE: These steps are not required if the receptor tray was not removed in a previous step. If the

receptor tray is already assembled, go to ″All Installations″ below.

Carefully move the receptor tray into position, rotating it up and in.

Make sure the subﬂoor cutout is large enough to prevent any contact with the backside of the receptor at

or near the drain.

Reconnect the receptor tray to the frame using the existing holes and the screws that were removed

previously.

Water Inlet

Drain Valve

Nut and O-Ring

Install, route and secure

accumulator drain line

to receptor tray.

Install drain and attach to receptor tray.

Approximately

1/4" (6 mm)

clearance required

from receptor tray.

Board

Strainer Body

Accumulator

Drain Line

2-1/2" (64 mm) Minimum Air Gap

Receptor Tray

Cable

Tie

Clamp

Drain Line

Pulley

Assembly

1128532-2-G 22 Kohler Co.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 155 156

No comments

Kohler K-1913-LW-47 Installation Guide Page 22