Kohler K-4026-0 Installation Guide download pdf (Page 4)

1. Prepare the Site

WARNING: Risk of electrical shock. Connect only to a properly-grounded, grounding-type

receptacle which is protected by a Ground-Fault Circuit-Interrupter (GFCI). Do not remove the

grounding pin or use a grounding adapter.

CAUTION: Risk of hazardous gases. If the new toilet is not installed immediately, temporarily

place a rag in the closet ﬂange.

NOTE: If the rough-in distance is less than 12″ (305 mm) the seat may strike the wall when it is opened.

Conﬁrm the rough-in is 12″ (305 mm) before installing the toilet.

Turn off the water supply.

Remove the old toilet.

Remove the wax residue from the ﬂange.

NOTE: T-bolts are not included.

Install two 5/16″ diameter T-bolts into the ﬂoor ﬂange.

Mark the centerlines for the outlet on the ﬂoor.

Install the electrical supply at the location shown.

Install the water supply at the location shown.

(152 mm)

12"

(305 mm)

2-3/4" (70 mm)

Supply Stop

Floor Flange

T-Bolt

Scrape off the old

wax seal.

Centerline

1221754-2-B 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 39 40

No comments

Kohler K-4026-0 Installation Guide Page 4