Kohler K-6228-C12-VS Installation Guide download pdf (Page 14)

6. Adjust the Valve - Right Handle

CAUTION: Risk of property damage. The water supply must be shut off before

performing these steps.

Shut off the water supply.

Remove the plaster guard/retaining ring tool.

Position a bucket at the spout outlet, then open the valve handle to relieve water

pressure. Leave the handle open.

Loosen the threaded retaining ring using the plaster guard/retaining ring tool

until the valve body disengages from the mixer valve.

CAUTION: Risk of property damage. At the maximum valve body extension, a

detent will be encountered. To avoid leakage, do not extend the valve beyond this

detent. If the valve body needs to be extended further, installation of the deep

rough-in valve body kit (1107027) is required. If the valve needs to be recessed

further, installation of the shallow rough-in valve body kit (1107026) is required.

Using a straight edge, adjust and hold the valve body ﬂush with the ﬁnished wall.

NOTE: A screwdriver inserted through the holes in the plaster guard/retaining ring

tool can serve as a handle.

With the valve body ﬂush with the ﬁnished wall, retighten the retaining ring with

the plaster guard/retaining ring tool.

Close the valve handle.

Turn on the water supply and check that the valve is functioning properly.

Threaded Retaining Ring

Anneau de retenue fileté

Anillo de retención roscado

Plaster Guard/

Retaining Ring Tool

Renfort en plâtre/

Outil d'anneau de retenue

Herramienta para

protector de yeso/

anillo de retención

1095311-2-H 14 Kohler Co.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

No comments

Kohler K-6228-C12-VS Installation Guide Page 14