Kohler K-6228-C12-VS Installation Guide download pdf (Page 16)

7. Adjust the Valve - Left Handle

IMPORTANT! Perform these steps when the handle will be located on the left side of

the spout.

CAUTION: Risk of property damage. The water must be shut off before performing

these steps.

Shut off the water supply.

Remove the plaster guard/retaining ring tool.

Position a bucket at the spout outlet, then open the valve handle to relieve water

pressure. Leave the handle open.

Loosen the threaded retaining ring using the plaster guard/retaining ring tool

until it disengages from the mixer valve body.

Pull out the valve body. The plaster guard/retaining ring tool can be threaded

onto the valve body to get a better grip on the valve body when pulling it out.

Rotate the valve body 180 degrees from the original position. This allows the

handle to move up when turning the water on.

Verify the O-rings on both the valve body and the mixer valve are undamaged.

Verify the spring plunger is installed and is ﬂush with the surface of the valve

body.

Reinstall the valve body into the mixer valve and fully seat the valve body into

the mixer valve.

CAUTION: Risk of property damage. At the maximum valve body extension, a

detent will be encountered. To avoid leakage, do not extend the valve beyond this

detent. If the valve body needs to be extended further, installation of the deep

Threaded Retaining Ring

Anneau de retenue fileté

Anillo de retención roscado

180˚

Plaster Guard/Retaining Ring Tool

Renfort en plâtre/Outil d'anneau de retenue

Herramienta para protector de yeso/anillo de retención

Valve Body

Corps de valve

Cuerpo de válvula

O-Rings

Joints-toriques

Arosellos

Spring Plunger

Plongeur de Ressort

Émbolo de resorte

1095311-2-H 16 Kohler Co.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

No comments

Kohler K-6228-C12-VS Installation Guide Page 16