Kohler K-1154-47 Installation Guide download pdf (Page 13)

10. Test Run the Whirlpool

Check all electrical connections, and make sure the electrical power to the whirlpool and heater (if

equipped) is on.

Make sure all union connections to the pump and heater are securely hand tightened.

Verify that the pump banding straps have been cut (if applicable), and that the pump is resting

directly on the subﬂoor or whirlpool base.

Fill the whirlpool to a level at least 2″ (5.1 cm) above the top of the highest jet.

Operate the whirlpool for 5 minutes, and check all whirlpool piping connections for leaks.

For additional information on whirlpool operation, refer to ″Conﬁrm Proper Operation.″

Fill with water at least 2" (5.1 cm)

above the highest jet.

Turn the jet trim ring

clockwise to

decrease the flow.

Position the jet

nozzles to direct

the water flow as

desired.

Turn the jet trim ring counterclockwise

to increase the flow.

Press the air switch to turn the

whirlpool on or off.

Kohler Co. 13 1010564-2-H

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

No comments

Kohler K-1154-47 Installation Guide Page 13