Kohler K-1154-47 Installation Guide download pdf (Page 15)

12. Complete the Finished Wall

Tiled Ledge Installation

If you have not already done so, carefully remove the protective tape from the whirlpool rim.

Cover the framing with water-resistant wall material.

Tape and mud the water-resistant wall material. Install the ﬁnished wall to the water-resistant wall

material.

Seal the joints between the whirlpool rim and the ﬁnished wall material with silicone sealant.

Install the faucet trim according to the instructions packed with the trim.

13. Clean-Up After Installation

When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the

whirlpool surface. Use warm water and a liquid detergent to clean the surface.

Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners

containing petroleum distillates to remain in contact with any whirlpool surfaces for long periods

of time. Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire

brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild

abrasive action to any residual plaster.

14. Conﬁrm Proper Operation

Fill the Whirlpool

NOTE: Please read these steps carefully before you operate your whirlpool.

Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully

counterclockwise.

Fill the whirlpool to a water level at least 2″ (5.1 cm) above the top of the highest jet.

NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C).

To service oriﬁces insert a pencil into the end of the jet nozzle and push the oriﬁce out. After

removing any blockage, check the oriﬁce to make sure it is clear and press it into the jet housing.

NOTE: Oriﬁces are only installed in whirlpool jets when there are six or more jets in the whirlpool system.

Operating Sequence

Press the air actuator to turn on the whirlpool jets.

Apply silicone

sealant to the

joint between the

finished wall and

the whirlpool rim.

Install the finished

ledge material.

First install water-resistant

wall material.

Install the finished

wall material.

Apply silicone sealant to the

joint between the finished

wall and the whirlpool rim.

Finished

Ledge

Whirlpool Flange

Framing

Kohler Co. 15 1010564-2-H

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Comments to this Manuals

No comments

Kohler K-1154-47 Installation Guide Page 15

Comments to this Manuals

Related products and manuals for Space heaters Kohler K-1154-47