Kohler 4737-0 Installation Guide download pdf (Page 4)

Prepare Electrical Connections (cont.)

Preferred Connection

Determine the electrical outlet location. The electrical outlet

should be located within 12″ (30.5 cm) of the toilet to

accommodate the length of the power cord. An extension cord

cannot be connected to the seat’s power cord.

Route the electrical wires, then install and ground the electrical

outlet. This electrical outlet must be a dedicated, nominal 120

VAC, 60 Hz circuit protected by a minimum 15 A Ground-Fault

Circuit-Interrupter (GFCI) or Residual Current Device (RCD). Do

not insert the plug into the electrical outlet at this time.

Temporary Connection

NOTICE: Unless the cover screw is grounded through the house

wiring, attaching the adapter grounding screw tab to the cover

screw will NOT ground the unit. If there is any doubt whether

cover screw is grounded, have it checked by a qualiﬁed electrician

or service professional.

A temporary connection with a two-prong adapter may be made

where local codes permit, provided that the adapter is grounded.

2. Prepare the Toilet

If applicable, remove the existing toilet seat.

Turn off the water supply to the toilet.

Flush the toilet to relieve any pressure from the water supply

hoses.

Position a container under the ﬁll valve to catch any excess water.

Disconnect the water supply hose from the toilet ﬁll valve.

1097712-2-A 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 27 28

No comments

Kohler 4737-0 Installation Guide Page 4