Kohler k-10951 User Manual download pdf (Page 20)

Troubleshooting Guide (cont.)

Symptoms Probable

Causes

Recommended Action

E. There is

water

leakage on

electrical

components

or

connectors.

E. Remove the spout and check

for corrosion on connections

between AC unit to solenoid

and the solenoid to sensor. If

possible clean terminals. If you

are unable to repair the

connection, order a new battery

assembly or sensor assembly, as

required. The origin of the leak

must be investigated and

repaired.

F. The AC

unit does

not work.

F. Measure the voltage of the unit.

The voltage should measure 6

Volts. If there is no power or

low power is detected, order a

new unit.

3. No water

ﬂow (Either

AC or DC).

A. Sensor

eyes are

dirty.

A. Wipe the sensor eyes with a

damp soft cloth. Wipe dry with

a dry soft cloth.

B. Water not

turned on.

B. Verify that the water supply is

turned on and that pressure is

at least 20 psi (137 kPa).

C. Incorrect

installation.

C. Verify that the faucet is

mounted ﬂat to the deck

surface and that the sensor eyes

are aligned to the user area.

Ensure that the sensor eyes are

above the rim of the lavatory.

Refer to the installation

instructions.

D. The

ﬁlter(s) are

plugged.

D. Turn off the water supply and

disconnect the ﬁttings from the

ﬂex hoses. Remove the ﬁlter

cartridges from both supplies.

Clean all debris from the ﬁlter

screens and reinstall the

screens, and reinstall the ﬁlter

cartridges.

E. The

aerator is

plugged.

E. Remove the aerator and clean.

For calcium/mineral deposits,

soak the plastic insert in a 50:50

mix of water and vinegar. Soak

only the plastic insert.

1025498-5-H 20 Kohler Co.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 75 76

Comments to this Manuals

No comments