Kohler K-1189-C1-96 Installation Guide download pdf (Page 6)

1. Roughing-In Information

NOTICE: The ﬂoor support under the whirlpool must provide for a minimum of 2000 lbs (907.2 kg).

Two separate 240 V electrical services are required: one for the pump/control, and one for the

heater.

Consult local and national codes for minimum air gap requirements when installing a spout on the

faucet deck.

The overﬂowing bath must be ﬁlled through the bathing well.

Hot water supply should be 70% of the capacity or greater.

The ﬁxture conforms to ANSI Standard Z124.1. All dimensions are nominal.

There is no change in measurements if connected with the drain illustrated (K-7193, K-7193M).

Cutout = 73-1/2″ (186.7 cm) x 39-1/2″ (100.3 cm)

An access panel is required. The recommended dimensions for this access panel are 40″ (101.6 cm)

Wx15″ (38.1 cm) H. Refer to the roughing-in diagram for suggested access panel location.

Make sure the ﬂooring is in good condition and offers adequate support for your bath.

IMPORTANT! Verify that the subﬂoor is ﬂat and level. This will help minimize the leveling adjustments

necessary for proper product performance.

No change in measurements if connected with drain

illustrated. (K-7193 or K-7193M)

Cut-out 73-1/2" (186.7 cm) x 39-1/2" (100.3 cm)

Pump/Control Access

40" (101.6 cm) W x 15" (38.1 cm) H

2" (5.1 cm)

31-1/2" (80 cm)

25"

(63.5 cm)

16-13/16"

(42.7 cm)

41"

(104.1 cm)

20-1/2"

(52.1 cm)

7-1/4"

(18.4 cm)

5-1/2"

(14 cm)

1-1/2" NPS

1-1/2" OD

1" (2.5 cm)

75" (190.5 cm)

63" (160 cm)

1" (2.5 cm)

3" (7.6 cm)

2-7/8" (7.3 cm)

1019731-2-D 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 63 64

Comments to this Manuals

No comments

Kohler K-1189-C1-96 Installation Guide Page 6

Comments to this Manuals

Related products and manuals for Unknown Kohler K-1189-C1-96