Kohler K-1257-VBR-96 Installation Guide download pdf (Page 3)

Before You Begin (cont.)

Determine the location of the control ampliﬁer if it will be installed remotely. The control ampliﬁer

includes a 25’ (7.6 m) cable.

A qualiﬁed electrician should install a 120 V, 15 A (240 V, 15 A in Latin America) GFCI or RCD

electrical outlet within the stud framing and within 24″ (610 mm) of the control ampliﬁer. The user

interface, transducers, and (if equipped) chromatherapy are powered through connections with the

control ampliﬁer.

Use conduit to route the electrical power wires from the circuit breaker.

Choose the location for a battery operated auxiliary audio device, if used. Do not locate devices

using AC power within reach of the bath.

Carefully plan moving the bath into the installation area. This bath will not easily ﬁt through

doorways.

Carefully uncrate the new bath and components and inspect for damage. Make sure there is no

damage to the bath. If there is a problem, do not install the bath. Report the speciﬁc problem to

your dealer immediately.

After inspection, return the bath and components to the carton until you are ready to install the

product.

Provide access to the control ampliﬁer connections for future servicing.

To ensure a successful bath installation, the ﬂoor must be level.

Provide adequate ﬂoor support.

Provide properly-dimensioned framing.

The basin area requires no additional support when the subﬂoor is level and square with the stud

framing. Consider using shims for additional support if the subﬂoor is uneven.

Plan for adequate mounting and connection space for the faucet.

This bath conforms to CSA B45.5/IAPMO Z124. All dimensions are nominal.

Kohler Co. 3 1188012-2-C

1 2 3 4 5 6 7 8 ... 59 60

No comments

Kohler K-1257-VBR-96 Installation Guide Page 3