Kohler K-14431-3-CP Installation Guide download pdf (Page 3)

1. Install the Spray Assembly

Remove the spray head and ﬂange.

Thread the nut, metal washer, and rubber washer to the bottom of the shank.

Apply a ring of plumbers putty or other sealant to the bottom of the ﬂange

according to the putty manufacturer’s instructions.

From the underside of the bidet, insert the shank through the spray hole.

From the top of the bidet, thread the ﬂange onto the shank.

NOTE: You may need to thread the ﬂange further down the shank to allow the spray

head to bottom out on the shank.

Thread the spray head onto the shank as far as it will go.

Thread the ﬂange up the shank until it is snug against the spray head.

Wrench tighten the nut to secure the spray head assembly. Do not overtighten.

Remove any excess putty or sealant.

Nut/Écrou/Tuerca

Spray Head

Tête du vaporisateur

Cabeza del rociador

Flange/Bride/Brida

Shank/Tige/Vástago

Bidet/Bidet/Bidet

Rubber Washer

Rondelle en caoutchouc

Arandela de goma

Metal Washer

Rondelle métallique

Arandela de metal

Kohler Co. 3 1144569-2-A

1 2 3 4 5 6 7 8 ... 27 28

No comments

Kohler K-14431-3-CP Installation Guide Page 3