Kohler K-2364-47 Installation Guide download pdf (Page 5)

Install the Lavatory (cont.)

Thread the hanger bolts into the ﬁnished wall until each hanger

bolt is exposed 1-1/2″ (3.8 cm) between the cap nut and the

ﬁnished wall.

Remove the cap nuts.

Install the faucet and drain to the lavatory according to the

manufacturer’s instructions.

Move the pedestal back into position.

Place the lavatory over the hanger bolts. Ensure the lavatory is

ﬂush against the pedestal and the ﬁnished wall.

Remove the lavatory from the pedestal. Set the lavatory aside.

CAUTION: Risk of product damage. Do not overtighten the

washer and lag bolt. Overtightening may damage the product.

Thread a washer and lag bolt through the hole in the pedestal

and into the ﬂoor until the washer contacts the pedestal. Do not

overtighten.

Carefully set the lavatory on the pedestal so the hanger bolts

extend through the lavatory anchoring holes.

Verify the installation is level and properly positioned.

CAUTION: Risk of product damage. Do not overtighten the cap

nuts. Overtightening may damage the product.

Thread a cap nut and washer over each hanger bolt until the

washer and the cap nut are tight against the lavatory.

Secure the P-trap to the drain.

Connect the water supply lines to the faucet according to the

manufacturer’s instructions.

Kohler Co. 5 1020683-2-E

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Kohler K-2364-47 Installation Guide Page 5