Kohler K-2822-1W-47 Installation Guide download pdf (Page 4)

2. Construct the Supports

NOTE: The following steps assume 2x4 stud framing is nominal

3-1/2″ (8.9 cm) x 1-1/2″ (3.8 cm). Make appropriate rip cut

modiﬁcations as necessary for other sized lumber.

Cut two 2x4 support studs to 36″ (91.4 cm). Rip cut these support

studs so they are 2-3/4″ (7 cm) deep.

Measure and cut a 1-1/2″ (3.8 cm) x 9-1/4″ (23.5 cm) notch in

each support stud so the bottom of the notch is 23-7/8″ (60.6 cm)

from the bottom of each support stud.

Position the support studs so a 3/4″ (1.9 cm) offset exists between

the front edge of the stud framing and the support studs.

Use nails or screws (not provided) of sufficient size and quantity,

and securely fasten the support studs to the stud framing. Space

the fasteners carefully in rows, and include a row to within 1″

(2.5 cm) of both the top and bottom of the notch.

Measure and cut a piece of 2x10 to ﬁt securely into the notch in

the support studs. Cut the 2x10 so it extends to both stud frame

sections, as shown. Temporarily ﬁt the 2x10 into the notch.

Fender

Washer

Wood

Screws

Bolt

Threaded

Inserts

1/2" (1.3 cm)

Holes

23-7/8"

(60.6 cm)

30-3/4"

(78.1 cm)

7-7/16"

(18.9 cm)

2-3/4" (7 cm)

3/4"

(1.9 cm)

36"

(91.4 cm)

1-1/2"

(3.8 cm)

9-1/4"

(23.5 cm)

3/4" Plywood

2"x10"

Lumber

1018372-2-B 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 23 24

Comments to this Manuals

No comments

Kohler K-2822-1W-47 Installation Guide Page 4

Comments to this Manuals

Related products and manuals for Unknown Kohler K-2822-1W-47