4. Shower Only Installations
NOTE: Shower only installation require 2-valve yokes.
NOTE: Typical dimensions for bath and shower installations are
shown on the rough-in diagram.
NOTE: Refer to the trim installations for specific requirements.
NOTE: Refer to the handle installation instructions for possible
rough-in depth requirements.
Unless otherwise instructed, rough-in the supply yoke 2-1/4″ (5.7
cm) minimum to 3″ (7.6 cm) maximum from the centerline of the
yoke to the outside of the finished wall.
Install 1/2″ hot and cold supply tubing.
If specified, install the screwdriver stop valves.
Using a 3/8″ hex wrench, remove the aspirator from the yoke and
discard.
Install a plug in the spout piping opening.
Plug
72"
(182.9 cm)
To Floor
24"
(61 cm)
113212-2-AC 6 Kohler Co.
Comments to this Manuals