Kohler K-3597-0 Installation Guide download pdf (Page 4)

2. Install the New Toilet

CAUTION: Risk of trap seal loss in back-to-back

installations. To prevent a trap seal loss, back-to-back toilet

installations must be connected to a vertical stack using one

of the following three ﬁttings: double ﬁxture, double

combination wye and 1/8 bends, or double wye and 1/8

bends.

Install or relocate the supply and outlet as necessary to conform

to the roughing-in dimensions.

Install a supply shut-off valve.

Lay the toilet down onto a padded surface.

From the bottom of the toilet, ﬁrmly press a new wax seal around

the toilet outlet.

Remove the temporary rag (if used) from the toilet ﬂange hole.

Align and lower the toilet over the ﬂange and T-bolts.

IMPORTANT! Do not lift or rock the bowl after placement. If you

break the watertight seal, you must install a new wax seal.

Apply your full body weight around the toilet to set the seal.

Place the bolt cap bases over the T-bolts in the ″up″ position as

marked.

Place the washers and nuts on the bolt cap bases and T-bolts.

Carefully tighten the nuts.

Bottom of Bowl

Wax Seal

Bolt Cap

Nut

Washer

Bolt Cap Base

T-Bolt

Closet Flange

1086530-2-A 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 19 20

No comments

Kohler K-3597-0 Installation Guide Page 4