Kohler K-705729-L-SHP Installation Guide download pdf (Page 12)

7. Assemble and Attach the Hinge Jamb

CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard

surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard

objects. Do not set the unframed tempered glass directly on the ﬂoor.

NOTE: Make sure you choose the correct hinge bracket. The weld nut groove should point towards the

near edge of the glass.

Slide two weld nuts into the groove of the lower hinge bracket and space them so that they align

with the holes in the door panel.

Insert a bushing onto each weld nut.

NOTE: There is a label on the door panel identifying the ″non-coated side″ of the panel. The bracket

should be located on the non-coated side of the door panel.

Position the bracket on the door panel so that the weld nuts pass through the two holes in the door

panel.

Position the back plate on the opposite side of the door panel, so that it hooks into the bottom of

the bracket.

Insert a screw into each of the two weld nuts through the slot in the back plate and tighten ﬁrmly.

Do not overtighten.

Repeat this procedure to install the top hinge bracket on the door panel.

Weld Nut

Lower Hinge Bracket

(groove aligns with

edge of glass panel)

Back Plate

Screw

Glass Door Panel

Inside of Shower

Bushing

Screw

1064866-2-C 12 Kohler Co.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

No comments

Kohler K-705729-L-SHP Installation Guide Page 12