Kohler K-T10594-4P-CP Installation Guide download pdf (Page 3)

1. Install the Valve Stem Adapter

IMPORTANT! Two screws of each length are supplied for this step,

one metric and one standard. If the screw you are using is difficult

to thread into the opening, remove it and use the other screw.

NOTE: Check the ﬁnished wall surface as related to the graphics on

the plaster guard.

Select the correct length valve stem adapter and valve stem

adapter screw for your application. Refer to the information

stamped on the plaster guard to verify the wall thickness.

For a thin wall - 3/16″ (5 mm) to 9/16″ (1.4 cm): use the 7/8″ (2.2

cm) (short size) valve stem adapter, stamped ″3″ on the plaster

guard. Use the 3/4″ (1.9 cm) screw for the top valve and the 1-3/8″

(3.5 cm) screw for the lower valve.

For a standard wall - 9/16″ (1.4 cm) to 1-1/16″ (2.7 cm): use the

1-3/8″ (3.5 cm) (middle size) valve stem adapter, stamped ″1″ on the

plaster guard. Use the 1-3/8″ (3.5 cm) screw for the top valve and

the 1-3/4″ (4.4 cm) screw for the lower valve.

For a thick wall - 1-1/16″ (2.7 cm) to 1-9/16″ (4 cm): use the 1-7/8″

(4.8 cm) (long size) valve stem adapter, stamped ″2″ on the plaster

guard. Use the 1-3/4″ (4.4 cm) screw for the top valve and the

2-3/8″ (6 cm) screw for the lower valve.

Remove and discard the plaster guard from the valve.

Select the correct

valve stem adapter.

Remove and discard

the plaster guard.

Valve Stem

Adapter

Spline

Adapter

Finished

Wall

Kohler Co. 3 1041504-2-E

1 2 3 4 5 6 7 8 ... 31 32

No comments

Kohler K-T10594-4P-CP Installation Guide Page 3