Kohler K-T10594-4P-CP Installation Guide download pdf (Page 9)

4. Install the Trim - K-T10422

Firmly press the valve stem adapters onto each of the valve

stems.

Secure the valve stem adapters to the valve stem with the correct

length screws, as selected in the ″Install the Valve Stem Adapters″

section of this guide.

Thread the two threaded studs into the threaded holes of the

valve.

Place the front plate assembly over the threaded studs.

NOTE: If the front plate assembly does not lay ﬂat on the wall

surface, loosen the nuts and adjust the threaded studs, then

re-tighten the nuts. The maximum distance between the threaded

studs from the wall is 7/16″ (1.11 cm).

Inspect the front seal plate assembly to ensure that the foam seal

is completely covering the wall opening. If not, stop the

installation and repair the wall opening.

Place the escutcheon against the wall. The drain hole in the

escutcheon should face downward in the 6 o’clock position.

Thread the adapter rings onto the hub of the front plate assembly.

Place the handle assemblies against the escutcheon by lining up

the pins in the handle assembly with the holes in the escutcheon.

Make sure the setscrew holes are facing down.

Valve Stem Adapter

Adapter Ring

Volume Control

Setscrews

Escutcheon

Thermostatic

Valve

Screw

Front Plate Assembly

Threaded Studs

Nuts

Handle

Assembly

Kohler Co. 9 1041504-2-E

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

No comments

Kohler K-T10594-4P-CP Installation Guide Page 9