Kohler Thermostatic Electric Shower User Manual download pdf (Page 12)

Drill and plug the top two xing holes. Secure the appliance to the wall with

the screws provided. Drill the bottom xing hole with the product in place.

Alternative xings (not supplied) may be necessary for some wall structures.

Avoid drilling into any supply cable/pipe.

Before tting the Cover, make sure that the appropriate cutouts have been

removed to suit the supply entering the product.

Thoroughly ush the mains-fed cold water supply pipe. The supply

must be clean and free from debris BEFORE connecting the appliance.

To ush the pipework, turn on the water supply and drain a minimum of 10

litres (2 gallons) of water into a bucket or catchment area. Turn off the water

supply.

An installation template is supplied to help you install the Mira Azora.

Put the installation template on the wall and mark through the positions of the

xing holes. Ensure the position of these holes do not come in line with any

buried cables or pipework. Make sure that sufcient electrical supply cable is

available for connection to the terminal block.

Determine the direction of the inlet

water supply: top (falling), bottom

(rising), or back inlet .

Note! Make sure that the back inlet

does not go directly back into the

wall. Use a soldered elbow.

Swivel the inlet connector assembly

to suit. Remove the inlet blanking

cap. Avoid trapping the green earth

bonding wire.

Install the mains-fed cold water

supply pipe. Do not overtighten.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

No comments

Kohler Thermostatic Electric Shower User Manual Page 12