Kohler T45106-4E-CP Installation Guide Page 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 1
Tools/Outils/Herramientas
Important Information
CAUTION: Risk of personal injury. If the water temperature is set too high,
scalding will occur. The water temperature should never be set above 120°F
(49°C).
NOTICE: Risk of product damage. Do not force the handle in any direction. Forcing
the handle will damage the valve.
NOTICE: Risk of product damage. The long [2-3/8 (60 mm)] screws, for installing
trim, can damage the K-2971-KS valve. When using this valve and trim with wall
thicknesses less than 13/16 (21 mm) thick, use the short [1-5/8 (41 mm)] screws.
NOTICE: Risk of product damage. Do not attempt to remove the flow regulator
from the showerhead.
Observe all local plumbing and building codes.
The finished wall or bath/shower unit must be installed prior to installing the
trim.
If the wall thickness is greater than 3/4 (19 mm) a deep rough-in kit is required.
Consult the specification sheet for the specific kit.
Valve Identification: When installing valve trim with diverters, you will need to
know your valve model. The K-11748 valve has a threaded diverter stem; the K-305
valve has a smooth diverter stem.
IMPORTANT! If installing trim to the K-305 valve a diverter button kit is required.
Consult the specification sheet for the specific kit.
Informations importantes
ATTENTION: Risque de blessures corporelles. Si la température d’eau est trop
haute, des risques de brûlures peuvent avoir lieu. La température de l’eau ne
devrait jamais être supérieure à 120°F (49°C).
NOTICE: Risque d’endommagement du produit. Ne forcer la poignée dans aucune
direction. Forcer la poignée endommagera la valve.
NOTICE: Risque d’endommagement du produit. Les vis longues [2-3/8 (60 mm)],
pour l’installation de la garniture, peuvent endommager la valve K-2971-KS. Lors de
Plumbers Putty
Mastic de plombier
Masilla de plomería
Silicone Sealant
Joint en silicone
Sellador de silicona
Sealant Tape
Ruban d'étanchéité
Cinta selladora
Strap Wrench
Clé à sangle
Llave de correa
Plus/Plus/Más:
• 1/2" Copper Tube or Nipple
Tube ou mamelon en cuivre 1/2" NPT
Tubo de cobre o niple de 1/2" NPT
• Rags/Chiffons/Trapos
• Emery Paper/Papier émeri/Papel lija
1/8"
1153319-2-C 2 Kohler Co.
Page view 1
1 2 3 4 5 6 7 ... 19 20

Comments to this Manuals

No comments