5.9
Section 5
Fuel System and Governor
5
Figure 5-14. Float and Inlet Needle Details.
ȱ Ŝǯȱ ȱȱĚȱȱȱȱȱȱȱ
seat and carburetor body. Install the new pivot
ȱȱȱĚȱȱȱȱȱȱ
ȱȱǯȱȱȱśȬŗśǯ
Figure 5-15. Installing Float Assembly.
ȱ ŝǯȱ ȱȱȱ¢ȱȱȱĚȱ¢ȱ
hangs vertically and rests lightly against the
fuel inlet needle. The inlet needle should be
fully seated but the center pin of the needle (on
retainer clip end) should not be depressed. Check
ȱĚȱȱǯ
DZȱ ȱȱȱȱȱȱȱ
ǯȱȱȱȱĚȱȱȱ
the fuel inlet needle without depressing
the center pin.
ȱ Şǯȱ ȱȱĚȱȱĴȱȱ17 mm (0.669
in.) ± 1.5 mm (0.059 in.)ǰȱȱȱȱĚȱ
Ĵȱȱȱ¢ȱȱȱǯȱȱȱ
śȬŗŜǯȱȱȱĚȱȱȱȱȱěȱ
ȱęǯȱDO NOTȱĴȱȱȱ¢ȱ
ȱĚȱǯ
DZȱ ȱȱȱȱȱȱȱ
surface, not the rubber gasket, if still
Ĵǯ
Figure 5-16. Checking Float Height.
ȱ şǯȱ ȱȱȱĚȱȱȱǰȱ
carefully reinstall the fuel bowl, using new
Ȭȱȱȱǯȱȱȱȱȱ
original screws. Torque the screws to
2.5 ± 0.3 N·m (23 ± 2.6 in. lb.)ǯȱȱȱśȬŗŝǯ
Figure 5-17. Installing Fuel Bowl.
10. Install the carburetor and reassemble the engine
ȱȱȱȱŗŖȱȃ¢ǯȄ
Disassembly/Overhaul
1. Clean the exterior surfaces of dirt or foreign
material before disassembling the carburetor.
Remove the four mounting screws and separate
the fuel bowl from the carburetor. Transfer any
remaining fuel into an approved container.
ȱȱȱȱȱȬǯȱȱ
can also be drained prior to bowl removal by
Ȧȱȱȱȱȱǯȱȱ
ȱśȬŗŞǯ
Float
Inlet
Needle
Clip
Retaining
Screw
Pivot
Pin
Comments to this Manuals