5.10
Section 5
Fuel System and Governor
Figure 5-18. Fuel Bowl Removed From Carburetor.
DZȱ ȱ¢ȱȱȱȱȱ
is not necessary unless the Fuel
Solenoid Kit, or Fuel Bowl Kit (obtained
separately), will also be installed.
ȱȱŘǯȱ ȱȱĚȱȱȱȱĞȱȱȱȱ
ĚǰȱǰȱȱȱǯȱȱȱśȬŗşǯȱ
Discard all the old parts. The seat for the inlet
needle is not serviceable, and should not be
removed.
Figure 5-19. Removing Float and Inlet Needle.
ȱ řǯȱ ȱȱȱ£ȱĚȱǰȱȱ
carefully remove the two main jets from the
carburetor. Note and mark the jets by location for
ȱǯȱȱȱȱ¢ȱȱ£Ȧȱ
ęǯȱĞȱȱȱȱȱǰȱȱȱ
££ȱȱȱȱȱȱȱĴȱ
ȱȱȱǯȱȱȱȦȱ
of the nozzles. The end with the two raised
ȱȱȱȦȱȱȱȱ
main jets. Save the parts for cleaning and reuse.
ȱȱśȬŘŖǯ
Figure 5-20. Main Jets and Nozzles Removed.
ȱ Śǯȱ ȱȱȱȱȱĚȱȱȱ
ground lead (if equipped), from the top of the
Dzȱȱ¢ȱȱǻĞǼȱȱȱȱ
ȱǯȱȱȱȱ¢ȱȱ£Ȧȱęǰȱ
mark or tag for proper reassembly. Note the small
ȬȱȱȱĴȱȱȱǯȱȱȱśȬŘŗȱ
ȱśȬŘŘǯȱȱȱȱȱȱȱȱ
a Jet Kit is also being installed. Clean the slow
jets using compressed air. Do not use wire or
carburetor cleaner.
Figure 5-21. Removing Screw and Washer.
Figure 5-22. Slow Jets and O-Ring Detail.
Float
Inlet
Needle
Fuel Bowl
Bowl Drain Screw
Main Jets
Main Nozzles
Slow (Idle Fuel) Jets
O-Ring
Comments to this Manuals