Kohler K-1461 User Manual download pdf (Page 7)

Troubleshooting

NOTICE: This section is for general aid only. A Kohler Authorized Service Representative or qualiﬁed

electrician should correct any electrical problems. For warranty service, contact your dealer or wholesale

distributor.

Remove the Jets

Position the ball nozzle of the jet facing up. This will ensure the jet tool will not slip off.

Position the jet tool (provided) with the hook facing up.

Insert the jet tool into the opening of the jet and hook the inside top of the nozzle.

Place your thumb against the whirlpool wall while ﬁrmly grasping the jet tool.

Steadily pull the jet tool until the jet assembly pulls free from the housing. Be careful not to lose the

O-ring.

Reinstall the Jets

NOTE: To allow easy rotation and proper operation of the jet, the O-ring must be: (1) correctly positioned,

(2) lubricated, and (3) in good condition.

Install the O-ring onto the ﬁrst shoulder of the jet.

Using the silicone lube packet (provided), lubricate the O-ring to prevent noisy operation of the jet.

Carefully insert the jet into the housing, then lightly push and rotate the jet until it snaps into

position. Do not force the jet.

Verify the jet is installed correctly. The jet should turn smoothly both clockwise and

counterclockwise. Remove and reinstall, if necessary.

Troubleshooting Table

User Keypad and Pump

Symptoms Probable Causes Recommended Action

1. User keypad does

not illuminate when

power button is

pressed.

A. No power to control. A. Check wiring and connect power.

B. GFCI or RCD tripped. B. Reset GFCI or RCD.

C. Wiring harness from user

keypad to control is loose,

disconnected or damaged.

C. Check wiring for proper connections.

Replace wiring harness if necessary.

D. User keypad does not work. D. Replace user keypad.

E. Control does not work. E. Replace control.

Remove the Jets

Insert the tool hook as shown and pull the jet out of the

housing. The jet should be facing up when this is done.

Housing

Reinstall the Jets

Insert the jet into the housing, and lightly

push and rotate until it snaps in position.

Inspect and

lubricate the O-ring.

Slide the O-ring

onto the first

shoulder of the jet.

Kohler Co. 7 1022231-5-C

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Comments to this Manuals

No comments

Kohler K-1461 User Manual Page 7

Comments to this Manuals

Related products and manuals for Kitchen Kohler K-1461