Kohler K-3901-0 Installation Guide download pdf (Page 10)

2. Prepare the Installation Location

IMPORTANT! Risk of product damage. If T-bolts are left in place, they will damage the toilet. Make sure

they are removed before moving the toilet into place.

If there are T-bolts extending from the ﬂange, remove them. T-bolts are not required for this

installation.

Cut out the inside of the ﬂange area on the template.

Position the template with the hole positioned over the ﬂange. It is critical that the centerlines

marked on the template are centered on the ﬂange.

Secure the template to the ﬂoor with tape.

IMPORTANT! Because of the unique design of this toilet, the width of the bottom edges of the toilet will

vary. The following steps are required because of this variation.

Conﬁrm the template is correctly positioned and centered over the ﬂange.

Position the toilet on the template. Make sure the front of the base of the toilet is aligned with the

markings on the template.

Position the toilet so an equal amount of shaded area is visible on each side of the template.

Conﬁrm the toilet is centered by measuring the amount of space on each side of the template.

Directly under the screw holes on each side of the toilet, accurately mark the bottom edge of the

base. The mark should intersect the lines labeled ″C″ and ″A″ or ″B″ on each side of the template.

Template

Screw Hole

Center the toilet

on the template.

Top View

For Wall Supply

Installations Only

For Through-

the-Floor

Supplies Only

Tape

Flange

Flange Centerlines

1212876-2-B 10 Kohler Co.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

No comments

Kohler K-3901-0 Installation Guide Page 10