Kohler K-1696-NA Installation Guide download pdf (Page 4)

1. Determine the Layout

WARNING: Risk of property damage. Allow a minimum of 12″ (30.5 cm) of air space around the

steam generator at all times. This provides an area for the heat generated by the unit to dissipate.

NOTICE: When installing the control kit, allow room in the control cable for a drip loop. The drip loop

will discourage moisture from following the control cable to the steam generator.

NOTICE: The steam generator will perform best when installed as close as possible to the steam head. The

unit should be installed within 25’ (7.62 m) of the steam head.

NOTICE: For optimum performance install the steam generator below the level of the steam head.

NOTE: When possible, use 45 degree elbows. Performance will be increased when 45 degree elbows are

used.

Determine the location of the steam generator. Allow for a 12″ (30.5 cm) air gap on all sides of the

generator. Allow for a drain pan.

Choose a drain pan appropriate for your installation. The drain pan is not supplied.

Tee

Steam Head

Control Cable Input

Pressure Relief Valve

Copper

Union

Shut-Off

Valve

Water

Inlet

Recommended

In-Line Water Filter

Front of Generator

(Access Panel)

Pitch toward generator.

Drain Pan

Install copper union as close

as possible to steam generator.

1053772-2-D 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 39 40

No comments

Kohler K-1696-NA Installation Guide Page 4