Kohler K-1696-NA Installation Guide download pdf (Page 5)

2. Determine the Location of the Steam Hardware

WARNING: Risk of scalding. Do not block the steam head or locate it near a seat or bench, as the

steam head is hot during operation and may scald the user if touched.

Steam Head and Control Applications

NOTE: All dimensions should be taken from the inside of the shower.

IMPORTANT! Do not install the control directly above or in-line with the steam head.

Refer to the Steam Control Kit Installation Instructions for more information.

It is recommended to locate the steam heads and the steam control on the same wall as the

plumbing controls.

Locate the steam heads 6″ (15.2 cm) above the shower ﬂoor and 4 1/2″ (11.4 cm) from the threshold.

Locate the steam control 60″ (152.4 cm) above the ﬂoor of the shower, but not directly in-line with

the steam heads. Refer to the Steam Control Kit Installation Instructions for more dimensional and

installation information.

Make sure there is adequate clearance between the steam lines and any surrounding surfaces.

Wall Stud

6" (15.2 cm) from Floor

Provide clearance

from wall.

2-1/2" (6.4 cm)

Kohler Co. 5 1053772-2-D

1 2 3 4 5 6 7 8 9 10 ... 39 40

No comments

Kohler K-1696-NA Installation Guide Page 5