Kohler K-3341-NA Installation Guide download pdf (Page 6)

Install the Sink (cont.)

Ensure there are no gaps between the sink rim and the

countertop.

Allow the sealant to cure for at least 30 minutes before

proceeding.

Connect and tighten the trap to the strainer, and complete the

water supply connections to the faucet according to the

instructions packed with the faucet.

Run water into the sink and check for leaks.

Clean up with a non-abrasive cleaner.

Undercounter Installation

WARNING: Risk of personal injury. Metal surfaces are sharp

and can cause severe cuts. Use gloves and handle sink edges

carefully.

CAUTION: Risk of product damage. Do not cut, drill, or sand

the countertop while it is positioned over the ﬁxture.

Cut out the opening by carefully following the pencil line traced

from the template.

For Wood Countertops

Mark and pre-drill the wood screw holes at the locations shown

on the template.

Waterproof any exposed areas of wood.

For Marble/Stone Countertops

Position the countertop upside down on foam padding to protect

the surface. Mark and drill 3/8″ holes 5/8″ (1.6 cm) deep at the

locations shown on the template.

Use a setting tool and hammer to secure the anchors.

For All Installations

If the countertop has not been installed, install it at this time.

Drill the faucet holes according to the faucet installation

instructions.

Install the faucet to the countertop according to the faucet

manufacturer’s instructions.

Install the strainer to the sink according to the strainer

manufacturer’s instructions.

NOTE: Do not use adhesives or adhesive sealants.

1019945-2-B 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Kohler K-3341-NA Installation Guide Page 6