Kohler Bath with Airjets 1199249-2-A User Manual download pdf (Page 8)

4. Disconnect the Blower Motor - Remote

NOTICE: This section applies only to installations in which the blower motor and check valve are

being relocated.

NOTICE: Do not cut the blower piping for this installation.

NOTICE: You must relocate the check valve with the blower motor. Do not disconnect the check valve

from the tee.

Remove the Blower Motor and Check Valve

Disconnect the blower motor electrical plug from the control.

Remove any cable ties that support the blower motor cord.

Remove and retain the screw holding the check valve to the PVC elbow.

Remove and retain the four screws from the baseboard.

Slide the blower motor and check valve away from the elbow, and remove the blower motor from

the bath.

Prepare the Site

NOTE: Refer to the ″Prepare the Blower (Remote Site)″ section for blower relocation details.

Prepare the site where the blower motor will be installed. The site must be within 15’ (4.5 m) of the

bath.

Install an access panel to service the blower motor.

Prepare the routing paths for the PVC piping and the new blower motor power cable. Follow all

applicable codes.

Elbow

Screw

Baseboard

Control

To Blower Motor

Cover

Blower Motor

Mounting Screws

Check

Valve

Blower Motor

Electrical Plug

Junction Box

1199249-2-A 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 63 64

No comments

Kohler Bath with Airjets 1199249-2-A User Manual Page 8