Kohler K-12231-CP Installation Guide download pdf (Page 3)

1. Handspray Installation

Apply a bead of plumbers putty or other sealant to the underside

of the spray holder according to the manufacturer’s instructions.

Insert the spray holder through the sink hole.

Securely hand tighten the nut from under the sink.

Remove any excess putty or sealant.

2. Spout Installation

Slide the escutcheon and gasket to the spout.

Partially thread two screws into the threaded ring until they

protrude slightly from the backside of the threaded ring.

Run the handspray hose down through the handspray holder.

Slide the threaded ring and washer on the handspray hose.

Run the handspray hose up through the spout mounting hole and

attach it to the handspray hose connector on the spout.

Position the spout in the desired mounting position.

Slide the metal washer onto the shank.

Thread the ring up the shank until it is about 1/4″ (6 mm) away

from the underside of the sink. Ensure the screw holes face the

front and back of the faucet.

Tighten the screws.

Hose

Sink

Nut

Handspray

Spray

Holder

Apply

plumbers

putty.

Spout

Sink

Washer

Ring

Screws

Gasket

Escutcheon

Handspray

Hose

Connector

Spray Hose

Kohler Co. 3 1036179-2-C

1 2 3 4 5 6 7 8 ... 19 20

No comments

Kohler K-12231-CP Installation Guide Page 3