Kohler K-2972-KS-NA Installation Guide download pdf (Page 13)

Install the Valve (cont.)

NOTE: If the existing hot and cold plumbing makes this

conﬁguration inconvenient or if it is advantageous to reverse the hot

and cold ports (such as back-to-back installations), see the ″Reverse

the Inlet Supplies″ section.

For K-2973 and K-2976 valves, make certain that the integral

volume control/shut-off valve portion of the assembly is on top

when installed.

Connect the water outlet lines to the valve ports. Plug any

unused outlet port.

IMPORTANT! Secure the piping to the framing.

NOTE: When using the plaster guard to trace the cut-out, the tick

marks located outside of the guard will assist you in identifying the

spline centers.

Use the plaster guard to determine the depth of the valve in the

wall, and to trace the cut-out line in the wall material.

NOTE: The ﬁnished wall must be within the MIN-MAX depth

shown on trim adapters 1, 2, and 3 of the plaster guard.

Turn on the water supply lines to the valves.

Run water through the mixing valve, all showers, and the spout.

Remove the plaster guard to access and inspect the valve.

Kohler Co. 13 1205551-2-B

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 87 88

No comments

Kohler K-2972-KS-NA Installation Guide Page 13