Kohler K-2972-KS-NA Installation Guide download pdf (Page 19)

Check the Temperature Setting

NOTE: The thermostatic valve cartridge is calibrated at the factory

for a shower temperature of approximately 104°F (40°C) to 105°F

(41°C) and a maximum hot temperature of 120°F (49°C).

Turn the water on.

Attach a trim handle or plaster guard (found in volume control

valve K-2974 or K-2977 or transfer valve K-728) onto the valve

spline adapter.

Turn the spline adapter fully counterclockwise so the trim handle

or plaster guard can no longer move. The spline adapter is now

in the full hot position.

Allow the water to run for several minutes to stabilize the water

supply temperatures.

Position a thermometer in the water stream to check the

temperature of the hot water.

If the water temperature exceeds 120°F (49°C) or is less than

desired, proceed to the ″Adjust the Hot Temperature Limit″

section.

Turn the trim handle or plaster guard clockwise until you hear a

click. Do not turn any further. This is the shower temperature

position.

Remove the trim handle or plaster guard from the valve spline

adapter.

Decrease Temperature

Increase Temperature

Spline

Adapter

Kohler Co. 19 1205551-2-B

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 87 88

No comments

Kohler K-2972-KS-NA Installation Guide Page 19