Kohler K-2972-KS-NA Installation Guide download pdf (Page 14)

3. Reverse the Inlet Supplies

IMPORTANT! The steps in this section are optional. Only perform

these steps when the hot and cold inlet supplies are reversed.

The inlet connections are indicated on the inlet ports of the

thermostatic valve assembly. Left is HOT and right is COLD. If this

conﬁguration is not suitable for your installation, the cartridge may

be rotated 180° to reverse the hot and cold inlet ports.

NOTE: DO NOT pull the removal clip from the cartridge assembly

at any time during this procedure. The retaining clip helps hold the

temperature limit stop and detent components in place and reduces

or eliminates the need for temperature adjustments.

With the valve already installed and pressurized:

Turn both integral supply stops 90° counterclockwise until they

contact the stop bracket.

Turn the volume control valve stem (not shown) fully clockwise

to release the pressure.

Slowly loosen the head nut, turning it counterclockwise. This will

begin to draw the cartridge out of the valve body.

Cartridge

Remove the cartridge and rotate 180˚.

Seal

Head Nut

Supply Stops

Tab

1205551-2-B 14 Kohler Co.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 87 88

No comments

Kohler K-2972-KS-NA Installation Guide Page 14