Kohler K-528-K-NA Installation Guide download pdf (Page 4)

Roughing-In

Before You Begin

NOTICE: Do not install the valve under a whirlpool surround or any location where the temperature may

exceed 104°F (40°C). The valve and its integrated power supply is rated to operate in temperatures up to

104°F (40°C).

NOTICE: Do not apply excessive heat near the valve or apply ﬂux or acids directly onto the valve. This

valve contains plastic and rubber components which will melt if heat is directly applied.

NOTICE: Do not apply petroleum-based lubricants to the valve components. Doing so will damage the

valve components.

NOTICE: Do not use oil-based, non-setting compounds, such as plumbers putty, on the threaded

connections.

NOTICE: If the digital valve will be used for a bath/shower application, the bath ﬁll supply line must be

routed from the #1 outlet port.

Read these instructions and determine the locations of all required components before beginning

installation.

For optimum performance, 1/2″ dedicated water supply lines are recommended.

When possible, install the valve prior to installing the interface(s).

If possible, ﬂush all piping thoroughly before installing the valve. If the pipes are ﬂushed after the

valve is installed, clean the inlet screens before using the system.

This valve is not intended for single-outlet use.

1-9/16"

(40 mm)

1-7/16"

(37 mm)

2-3/8"

(60 mm)

(51 mm)

1-13/16"

(46 mm)

13/16"

(21 mm)

1-5/16"

(33 mm)

3-3/8"

(86 mm)

(25 mm)

13-3/8" (340 mm)

11-5/8" (295 mm)

10-3/16" (259 mm)

8-1/16" (205 mm)

12-1/2" (318 mm)

9-7/16" (240 mm)

9-1/2"

(241 mm)

12-1/2"

(318 mm)

2-11/16"

(68 mm)

1145587-2-B 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 47 48

Comments to this Manuals

No comments

Kohler K-528-K-NA Installation Guide Page 4

Comments to this Manuals

Related products and manuals for Sanitary ware Kohler K-528-K-NA