Kohler K-7338-4-BS Installation Guide download pdf (Page 5)

2. Install the Wall Shanks

Remove the caps from the pipe nipples.

Reinstall the wall shanks to the pipe nipples.

Measure and note the distance ″X″ from the end of the wall

shanks to the ﬁnished wall.

Remove the wall shanks.

Remove the pipe nipples and measure their length.

Subtract distance ″X″ from the length of the pipe nipples. Discard

the pipe nipples and replace them with ones of proper length.

Apply sealant tape to both ends of the pipe nipples, then insert

the pipe nipples into the elbows.

Thread the wall shanks to the pipe nipples, then tighten with a

3/8″ hex wrench.

For each wall shank, ensure the distance from the end of the wall

shank to the ﬁnished wall is equal. Adjust if needed.

Wall Shank

Finished Wall

Elbow

Pipe Nipple

Kohler Co. 5 1069114-2-A

1 2 3 4 5 6 7 8 9 10 ... 23 24

No comments

Kohler K-7338-4-BS Installation Guide Page 5