Kohler K-7338-4-BS Installation Guide download pdf (Page 6)

3. Install the Faucet Assembly

IMPORTANT! If you are mounting the escutcheons to an uneven

surface (such as tile grout lines), apply a suitable sealant in addition

to the foam gaskets provided. Do not use petroleum based sealant.

Conﬁrm that a foam gasket is inserted in the groove of each

escutcheon.

Slide an escutcheon onto each wall union shank

Press the escutcheon against the ﬁnished wall and tighten the

setscrews with a 5/64″ hex wrench.

Conﬁrm that an O-ring is attached to each wall union shank and

a rubber gasket is attached inside each union nut.

Slide the faucet assembly onto the wall union shanks.

NOTE: Do not damage the O-rings on the wall union shanks or the

ﬁnish on the union nuts when using the strap wrench.

Using a strap wrench, tighten the union nuts to secure the faucet

assembly to the wall union shanks.

Verify the handles are in the OFF position, as shown.

Foam Gasket

Escutcheon

Pipe Nipple

O-Ring

Rubber

Gasket

Union

Nut

Wall Union

Shank

1069114-2-A 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Kohler K-7338-4-BS Installation Guide Page 6