Kohler K-682-K-NA Installation Guide download pdf (Page 12)

7. Preparation

If not already installed, install the digital valve at this time according to the instructions packed

with the product.

NOTE: The optional auxillary interface, with the 4-pin cable, is located outside the showering enclosure,

while the primary interface, with the 8-pin cable, is located inside the showering enclosure.

Determine all required components along with their installation locations before beginning this

installation.

Custom showering experiences other than the preprogrammed options must be programmed into

the interface prior to use. Refer to the ″Digital Interface Homeowners Guide.″

The numbers marked at each valve inlet must correspond to the appropriate showering component

for the preprogrammed or custom showering experiences to function properly. Keep this in mind

when determining your component layout routing the piping.

30' (9.14 m) 8-Pin Interface Cable

30' (9.14 m) 4-Pin Interface Cable

Connector

Drip Loop

Drip Loops

Power Supply

Outlet

Primary Interface

(Inside Shower)

Auxiliary Interface

(Outside Shower)

1043183-2-B 12 Kohler Co.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

No comments

Kohler K-682-K-NA Installation Guide Page 12