Kohler K-682-K-NA Installation Guide download pdf (Page 15)

11. Complete the Installation

CAUTION: Risk of product damage. The power supply is rated to operate in temperatures up to

104°F (40°C). Do not install the power supply under a whirlpool surround or any location where the

temperature may reach temperatures over 104°F (40°C).

CAUTION: Risk of product damage. Do not plug in the power supply until all interface cables are

connected.

IMPORTANT! Make drip loops in all cables and cords.

If the interface(s) is/are not installed at this time, install now according to the instructions packed

with the product.

Hold the power supply up to the install location and verify the cord will reach to the electrical

outlet.

Mark the hole locations.

Pre-drill the holes.

Secure the power supply with the screws.

If not already installed, install the interface(s) at this time according to the instructions packed with

the product.

Press the clips to release and open the door on the valve.

Slide the hinge side of the door in either direction until one side slips free.

Remove the door.

Connect the interface cable(s) to the valve.

Connect the power supply to the valve.

Screws

Molded Grommets

Internal Interface Cable

Optional External

Interface Cable

Drip Loop

Clip

Tab

Door

Drip Loop

Power Supply

Kohler Co. 15 1043183-2-B

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

No comments

Kohler K-682-K-NA Installation Guide Page 15