Kohler K-14037-G-96 Installation Guide download pdf (Page 5)

Prepare the Site (cont.)

Ensure the subﬂoor is level.

Determine the location of the bath. Provide a minimum clearance of 24″ (610 mm) around the

perimeter of the bath. Additional space is recommended to ease installation.

Use the cut-out template provided with the bath to properly mark the water supply and drain

locations in relation to the chosen location of the bath.

Install an access panel to service the remote blower motor.

Prepare the routing paths for 1-1/2″ PVC piping and a keypad cable to run under the ﬂoor from the

blower to the bath. Follow all applicable building, ﬁre, plumbing, and electrical codes.

Determine the location on the ﬂoor where the PVC piping from the blower will exit from under the

ﬂoor to connect to the bath piping. Mark this location on the ﬂoor.

Cut the marked water supply and drain locations in the subﬂoor with a saw and hole saw.

Cut the hole for the blower PVC piping and keypad cable at the marked location on the ﬂoor.

Install the rough water supply and drain lines.

Install the ﬁnished ﬂooring material prior to installing the bath.

Ensure the ﬁnished ﬂoor is level before proceeding with the bath installation.

Kohler Co. 5 1220597-2-D

1 2 3 4 5 6 7 8 9 10 ... 59 60

No comments

Kohler K-14037-G-96 Installation Guide Page 5