Kohler K-1418-HE-0 Installation Guide download pdf (Page 10)

9. Install the Plumbing

CAUTION: Risk of property damage. Ensure a watertight seal on the whirlpool drain.

Connect the drain to the trap according to the drain manufacturer’s instructions.

NOTICE: An access panel will simplify future maintenance.

Install the faucet valving according to the faucet manufacturer’s instructions. Do not install the

faucet trim until instructed. Open the hot and cold water supplies, and check the supply

connections for leakage.

Run water into the whirlpool, and check the drain connections for leakage.

If your whirlpool requires grip rails, install them now according to the installation instructions

packed with the grip rails.

10. Make Electrical Connections

NOTE: The whirlpool model number is printed on a label near the whirlpool pump. This label also

identiﬁes the electrical rating of the whirlpool. All whirlpools come equipped with a wiring junction box

and will only operate at 220 V through 240 V and at 50 Hz or 60 Hz.

WARNING: Risk of electric shock. To reduce the risk of electric shock, connect the pump to a

properly grounded Ground-Fault Circuit-Interrupter (GFCI) or Earth-Leakage Circuit-Breaker (ELCB).

This will provide additional protection against line-to-ground shock hazard. A 220 - 240 V, 20 A, 50/60

Hz dedicated circuit is required.

WARNING: Risk of electric shock. Make sure the power has been disconnected before performing the

following procedures.

The whirlpool controls and system have been prewired at the factory. A licensed electrician should

make a routine service connection to the junction box.

Connect service to the junction box. The junction box contains blue, brown and green with a yellow

stripe colored wires and a ground lug.

Provide a separate equipment earthing conductor for the earth lug located inside the junction box.

The earthing conductor must not be connected to any current-carrying conductor. Follow local

electrical codes. Bond in accordance with national and local codes.

A wiring harness has been prewired at the factory, allowing communication between the keypad, all

features, and the control. No additional wiring is required, but ensure that all wires are securely

fastened.

Ground (Green with

Yellow Stripe)

Blue

Supply

60 Hz 50 Hz From Control

L1 L1 Brown

L2 N Blue

Electrician to

provide suitable

strain relief.

The junction box should be

wired as shown.

Bond in accordance with

national and local codes.

Wire

Connectors

From Control

Brown

Heater (models may

vary) T-style (shown)

or inline (not shown)

Heater Electrical Cord

Wiring

Harness

Junction

Box

Control

Pump

Electrical

Cord

1022199-2-D 10 Kohler Co.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Comments to this Manuals

No comments

Kohler K-1418-HE-0 Installation Guide Page 10

Comments to this Manuals

Related products and manuals for Unknown Kohler K-1418-HE-0