Kohler K-1652-NA Installation Guide download pdf (Page 13)

Troubleshooting Guide (cont.)

Symptoms Probable Causes Recommended Action

3. ″Err 3″ appears on the

control pad.

A. ″Down button″ is stuck. A. Reset the power at the breaker.

4. ″Err 4″ appears on the

control pad.

A. ″Time″ button is stuck. A. Reset the power at the breaker.

5. ″Err 5″ appears on the

control pad.

A. Maximum heat has been

exceeded. The generator is not

getting enough water.

A. Check the water supply for proper

ﬂow.

B. Water feed assembly is blocked. B. Remove and inspect the water feed

assembly in the generator.

6. ″Err 6″ appears on the

control pad.

A. Indicates ﬂoat switch tripped

for 10 seconds.

A. Shut off the system and allow it to

cool.

7. ″Err 7″ appears on the

control pad.

A. ″Temperature″ button is stuck. A. Reset the power at the breaker.

8. ″Err 8″ appears on the

control pad.

A. ″Clock″ button is stuck. A. Reset the power at the breaker.

9. Unit shuts off. A. Unit has been in operation for

more than 20 minutes.

A. Turn unit back on.

10. No steam is being

generated.

A. Piping not properly attached. A. Reattach the pipes properly.

B. Steam head blocked. B. Remove the steam head (after

cooling) and check that the plunger

slides freely in the cap.

11. There is a continuous

ﬂow of water from the

steam head. Water ﬂow

during automatic purge

cycle is normal.

A. Water supply incorrectly

attached to steam generator.

A. Connect the water supply to the

proper inlet.

B. Water feed assembly is stuck. B. Remove and inspect the water feed

assembly in the generator.

Kohler Co. 13 1008019-2-J

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Comments to this Manuals

No comments

Kohler K-1652-NA Installation Guide Page 13

Comments to this Manuals

Related products and manuals for Unknown Kohler K-1652-NA