Kohler K-1652-NA Installation Guide Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
2. Install the Piping
CAUTION: Risk of product damage. Do not apply excessive heat to the generator connections
when soldering. Do not apply flux or acids directly to the generator, as damage to the seals, plastic
components, and trim finish may result. Do not apply petroleum-based lubricants to the generator
components as damage may result.
WARNING: Risk of personal injury or property damage. Do not plumb the pressure relief valve
into the steam line. Plumbing the pressure relief valve into the steam line can create a hazard if the
steam line is blocked or obstructed.
WARNING: Risk of personal injury. Do not plumb a trap in the steam line or plumb the pressure
relief valve into the steam line. Plumbing the pressure relief valve into the steam line can be
hazardous if the steam outlet is capped.
WARNING: Risk of personal injury or property damage. Do not direct the pressure relief valve to
the enclosure. In the event the pressure relief valve activates, the hot water may spray causing
burns to the user and/or damage the enclosure. Therefore, the pressure relief valve should be
directed to an area where damage will not occur from contact with hot water and should conform
to national and local plumbing codes.
IMPORTANT! When installing the control pad, allow room in the control cable for a drip loop. The drip
loop will discourage moisture from following the control cable to the steam generator.
Connect a tee to the existing cold water line.
Install the brass shut-off valve to the tee.
IMPORTANT! The in-line water filter (recommended) must be installed between the shut-off valve and the
steam generator inlet.
If applicable, install the recommended in-line water filter to the shut-off valve.
1" (2.5 cm)
Min
2-1/2"
(6.4 cm)
6" (15.2 cm)
from Floor
Steam Head
Pitch toward
generator.
Drain/Spill Pan
Steam Trap
Do not run pipes
down and then up.
Wall Stud
Provide clearance
from wall.
Kohler Co. 7 1008019-2-J
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Comments to this Manuals

No comments