Kohler K-1954-0 Installation Guide download pdf (Page 11)

Connect the Module - Flapper Style (cont.)

Determine if the chain attached to the ﬂapper is long enough to

reach to the module wheel attachment point when adding the

large clip. It the existing chain is long enough, attach the large

clip to the chain and wheel.

If the original chain is not long enough, remove the clip on the

original chain.

Connect the small clip on the suppled chain to the end of the

original chain. The attachment point may vary from the model

shown.

Pull the chain tight from the ﬂapper to the wheel. Grasp the chain

link aligned with the connection point on the wheel.

Attach the large clip to the chain link even with the wheel

connection point.

Remove the large clip from the wheel, attach it to the marked

chain link, and reattach the large clip to the wheel.

Conﬁrm Operation

Manually turn the wheel and observe the ﬂapper.

For installations with the handle in place, conﬁrm the handle

chain and module chain do not interfere with each other.

Conﬁrm the chain and wheel do not contact the hose.

Conﬁrm the chain does not wrap on the axle. Adjust the module

position to align the chain closer to vertical if the chain wraps on

the axle.

Conﬁrm the ﬂapper lifts clear of the tank outlet when the chain

connection on the wheel is at the highest point.

Conﬁrm the ﬂapper is fully sealed when the wheel chain

attachment is at its lowest point.

Adjust the clip and add or remove slack if needed.

Remove Extra Chain

Go two chain links past the connection to the large clip and cut

the chain.

NOTE: Leaving more than two chain links hanging below the

wheel connection could result in the chain interfering with the

wheel, causing poor operation or continuously running water.

Kohler Co. 11 1216369-2-D

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

No comments

Kohler K-1954-0 Installation Guide Page 11