Kohler K-1954-0 Installation Guide download pdf (Page 6)

2. Determine the Bracket Location

If the water supply was not turned off previously, turn off the

water supply to the toilet.

If there is still water in the tank, ﬂush the toilet to remove most

of the water from the tank.

Close the toilet seat and seat cover to avoid dropping parts in the

bowl.

Remove the tank lid and with the back of the lid toward you

position it upside down on the seat cover or a surface covered

with a towel or other soft material.

Recommended: For tank lid stability, install four pads, two on the

front and two on the back, near each corner of the tank rim

where the lid contacts the tank rim. The pads stabilize the lid,

helping to stop false ﬂushes when the lid is bumped.

Position the module upside down on the right side of the lid,

against the inside of the lid ledge.

Position and hold the bracket on the back ledge as shown.

Note the number of the slot closest to the bottom tab.

Slot

Bottom Tab

Ledge

Bracket

Back of Lid

Module

Tank Lid

Top Tab

Pad

1216369-2-D 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 63 64

No comments

Kohler K-1954-0 Installation Guide Page 6