Kohler K-8817-CP Installation Guide download pdf (Page 7)

7. Install the Drain Control

CAUTION: Risk of poor product performance. Location of the cable drain control on the faucet deck

is critical to product performance. Make sure the 27″ (68.6 cm) control body will reach the sink drain

before the cable drain control is installed.

Remove the control ﬂange from the control housing and apply a ring of plumbers putty or other

sealant around the bottom of the control ﬂange according to the putty manufacturer’s instructions.

Assemble the ﬂange nut, plastic washer and gasket to control housing. The distance between the top

of the control housing and gasket must be larger than the faucet deck thickness.

From under the sink, lift the control housing up to faucet deck and turn the control ﬂange until

tight.

Align position of control housing as previously determined.

Push the control ﬂange onto the sink.

Tighten the ﬂange nut and remove excess putty or sealant.

8. Complete the Strainer Installation

Apply thread sealant tape to the control body.

Slide the nut onto the tailpiece and insert the small gasket.

Thread the tailpiece to the control body and tighten the nut securely with a wrench.

Apply

Plumbers

Putty.

Control

Flange

Control Knob

Indicator

Control Knob

Flange

Nut

Plastic

Washer

Control

Housing

Gasket

Control Body

Gasket

Tailpiece

Nut

Cable

(Assembled

to Control)

Kohler Co. 7 113776-2-AB

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Kohler K-8817-CP Installation Guide Page 7