Kohler K-99695-NA Installation Guide download pdf (Page 3)

FCC and IC Compliance (cont.)

1. This device may not cause harmful interference, and 2. This device

must accept any interference received, including interference that may

cause undesired operation.

NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and,

if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and the receiver.

•

Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

•

Consult the dealer or an experienced radio/television technician

for help.

Modiﬁcations: Any modiﬁcations made to this device that are not

approved by Kohler Co. may void the authority granted to the user by

the FCC to operate this equipment.

Speciﬁcations

Ambient Temperature Max 104°F (40°C)

Maximum Relative Humidity 90% non-condensing

Electrical Service 100-240 VAC, 50-60 Hz, 0.6-0.4 A

Ethernet Cable Length 25’ (7.6 m)

Kohler Co. 3 1218131-2-A

1 2 3 4 5 6 7 8 ... 59 60

No comments

Kohler K-99695-NA Installation Guide Page 3