Kohler K-T6277-C12-BN Installation Guide download pdf (Page 7)

4. Complete the Installation

Connect and tighten the water supply hoses.

Ensure that both faucet handles are turned off (hot = counterclockwise to close,

cold = clockwise to close).

NOTE: The spray must be removed and the lines ﬂushed or debris may block the

water ﬂow.

Remove the button cover from the spray assembly.

Push the button on the sprayhead in while sliding the tube down from the spout.

The setscrew will be visible.

Using a 5/64″ hex wrench, loosen the setscrew on the spout until the sprayhead

releases from the spout.

Open the valves and run water through the spout for about a minute to remove

any debris. Check for leaks.

Check that the setscrew will not interfere with the sprayhead. If the setscrew

protrudes into the area the sprayhead will be inserted, loosen it until it is ﬂush or

behind the interior surface of the spout.

Align the groove at the top of the tube with the pin on the end of the spout.

Slide the tube up until it stops and hold it in place.

While holding the tube up, push the sprayhead into the spout.

Retighten the setscrew.

Slide the tube up and reinstall the button cover.

Check the button for correct operation.

Button Cover

Cache-bouton

Tapa de botón

Setscrew

Vis de retenue

Tornillo de fijación

Sprayhead

Tête de vaporisateur

Cabeza del rociador

5/64" Hex Wrench

Clé hexagonale 5/64"

Llave hexagonal de 5/64"

Kohler Co. 7 1132653-2-C

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Kohler K-T6277-C12-BN Installation Guide Page 7