Kohler K-1154-CC-0 Use and Care Manual download pdf (Page 7)

Troubleshooting Procedures (cont.)

Symptoms Probable Causes Recommended Action

3. Whirlpool stops

automatically.

A. Pump has overheated and the

protection devices has activated.

A. Check for blockage at the motor

vents. Check for suction

blockage. Check for jet blockage.

Remove any blockage and allow

the motor to cool.

B. GFCI/RCD circuit has tripped. B. Identify source fault and correct.

Check that the GFCI/RCD has

not been tripped. If problem

persists, contact an electrician.

4. The motor starts but not

all jets function.

A. Jets are closed. A. Rotate the jet trim ring

counterclockwise to

open/increase ﬂow to the jets.

B. Jets are blocked or trim ring

rotation is impeded.

B. Debris may be obstructing the jet

opening or preventing the jet

trim ring from rotating. Remove

the trim ring and remove

obstruction.

C. Jets not installed correctly. C. Reinstall the jet; check for any

O-ring damage.

D. Pump is not supported correctly

and is cavitating.

D. Review the installation

instructions and verify that the

pump is at the appropriate

height and the pump banding

straps (when applicable) have

been cut.

5. Noisy pump operation. A. The pump banding straps have

not been cut.

A. Using tin snips, cut pump

banding straps.

6. Heater does not operate

(units with heaters only).

A. No power to heater or it is not

connected to a separate outlet

from the pump.

A. Verify that the heater is

connected to a separate outlet

from the pump and that the

connection has power.

B. The water temperature is above

104°F (40°C).

B. As a safety precaution, the heater

will not operate when the water

temperature is above 104°F

(40°C).

Kohler Co. 7 1010564-5-L

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments

Kohler K-1154-CC-0 Use and Care Manual Page 7

Comments to this Manuals

Related products and manuals for Space heaters Kohler K-1154-CC-0