Kohler Discovery User Manual download pdf (Page 21)

Reversed Supplies

The Discovery Dual Control is supplied with inlet connections Hot-Left, Cold-Right

and Top-Outlet as standard. If the hot and cold water supply pipes have been reversed

during installation the following procedure must be performed.

Note! Refer to illustrations in section: ‘Installation, Control Assembly’.

‘O’ Key

1. Isolate the hot and cold water supplies.

2. Pull off the temperature knob.

3. Unclip and remove the concealing

plate.

Note! Use a screwdriver in the slot at

the bottom of the concealing plate to

lever off.

4. Fit the ‘O’ Key (supplied) onto the

cartridge nut and turn anticlockwise.

Unscrew and pull the cartridge clear

from the body.

Note! Depending on the finished wall

thickness it may be necessary to

remove the backplate.

5. Rotate the cartridge 180°.

6. Make sure that the two cartridge side

seals are fitted and carefully push into

the cartridge body.

Important! Make sure that the

cartridge side seals do not extrude

from the body when pushing the

cartridge in. Damage to these seals

may result in incorrect operation.

7. Position the cartridge lugs into the

body slots and tighten the nut by

turning the ‘O’ Key clockwise.

8. Restore the hot and cold water

supplies and check for leaks.

9. Refer to section: ‘Installation, Control

Assembly’ and follow instructions 3

to 9.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

No comments

Kohler Discovery User Manual Page 21