Kohler K-487-CP Installation Guide download pdf (Page 2)

Tools and Materials

Before You Begin

DANGER: Risk of personal injury. These products are not

designed or intended for use as a grab bar or support bar. Do

not install any of these products in any area where they are

likely to be used inadvertently as a grab bar or support bar.

NOTICE: Measure the length of the bonnet included with your

accessory. Correspond the length of the bonnet with the [A] or [B]

bonnet dimension illustrated in the ″Roughing-in Information″

section. Refer to the [A] or [B] dimension throughout the installation

guide to achieve proper installation.

These products should be located and mounted to a wall stud.

While it is possible to mount them to any surface, a stud

mounted product will yield the best results.

Use a level to ensure that the center lines for the wall plates are

vertical where applicable and the post center lines are horizontal

where applicable.

Kohler Co. reserves the right to make revisions in the design of

products without notice, as speciﬁed in the Price Book.

Level

Pencil

Compass

Claw

Hammer

Assorted

Screwdrivers

Drill & 5/16" Bit

Assorted Hex

Wrenches

Measuring

Tape

• Assorted woodworking

tools

Plus:

1020823-2-D 2 Kohler Co.

1 2 3 4 5 6 7 ... 39 40

No comments

Kohler K-487-CP Installation Guide Page 2